how to install an awning on a vinyl siding house

That is where this handy guide comes in. If that is the case, you will need to add the bracing from the inside walls of the building. Extend and hose off your awning every several weeks, allowing it to air dry. That's a good one. Begin by marking a line across the wall for the ledger's top edge. Remove a piece of siding and identify it. Every awning manufactured has a minimum mounting height. Another crucial tool to correctly mount your awning is a quality tape measure to verify the mounting locations are spaced evenly. By clicking Accept all cookies, you agree Stack Exchange can store cookies on your device and disclose information in accordance with our Cookie Policy. We will go with the preformed bar in this installation. wikiHow, Inc. is the copyright holder of this image under U.S. and international copyright laws. Remove trim ring. How to Remove a Metal Window Awning - SFGATE Be sure to put the head of the bolt on the outside to avoid tearing fabric. Check your instruction manual to see exactly what hardware you should be using. Small long stainless steel screws or nails, long enough to penetrate the house sheathing through slightly oversized pilot holes or peel & stick numbers. Be sure to have all of the lag bolts driven before letting go of the awning. Finding the studs is the. Take it to a siding retailer or distributor. Heres a list. Drive a flat bar between the nailheads and siding and carefully pull the nails. Lift the unlocked siding to expose the nailing hem of the siding piece below. Start by making an outline on the siding where you want to position the ledger board. Locate the piece you want to remove and unlock the one above it with the zip tool (Photo 1 inset). Make sure that the window is entirely secure. Be sure to follow manufacturer instructions. Awnings come in fixed or retractable styles and numerous sizes, ranging from just large enough to shield a door or window from the sun to sizes that can provide shade over an entire patio. Start by making an outline on the siding where you want to position the ledger board. Buy a 10-in.wide roll of aluminum (at home centers), and cut it into 5-in.wide strips for the top and sides of the window. Using a stud finder, locate the full left to right width of the header and axial studs. Simply loosen the lock nut, screw the adjuster in or out to insure the canopy is level, and tighten the lock nut. Then slip flashing behind the siding, covering the top edge of the ledger. 1830 farm house - installing metal vertical siding over original clapboards. One thing to consider when ordering your awnings is the location of the nearest electrical outlet. Wall assemblies that incorporate rigid foam insulation over exterior sheathing, followed by furring strips and siding, are becoming common. Get the latest This Old House news, trusted tips, tricks, and DIY Smarts projects from our expertsstraight to your inbox. At one end, fasten the mounting bar using appropriate hardware. Although this siding is low maintenance, it cannot support heavy loads and cracks easily when stressed. This image may not be used by other entities without the express written consent of wikiHow, Inc.
\n<\/p>

\n<\/p><\/div>"}, {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/5\/54\/Install-an-Awning-Step-9.jpg\/v4-460px-Install-an-Awning-Step-9.jpg","bigUrl":"\/images\/thumb\/5\/54\/Install-an-Awning-Step-9.jpg\/aid11468841-v4-728px-Install-an-Awning-Step-9.jpg","smallWidth":460,"smallHeight":345,"bigWidth":728,"bigHeight":546,"licensing":"