b. Subpart O: Machinery and Machine Guarding, OSHA 1910 General Industry | UpCodes Subpart O Machinery and Machine Guarding Authority: 29 U.S.C. (4) Openings for oiling. (4) If there is a counterweight, one of the following or equivalent means shall be used to prevent its dropping: (i) It shall be bolted to the bar by means of a bolt passing through both bar and counterweight; (ii) A bolt shall be put through the extreme end of the bar; (iii) Where the counterweight does not encircle the bar, a safety chain shall be attached to it; (iv) Other types of counterweights shall be suspended by chain or wire rope and shall travel in a pipe or other suitable enclosure wherever they might fall and cause injury. (1) General requirements. (iii) The intensity of illumination conforms to the requirements of ANSI A11.1-1965 (R-1970), which is incorporated by reference as specified in 1910.6. fOSHA Conveyor Standards On both sides of the calender and near each end of the face of the roll, there shall be a cable or wire center cord connected to the safety trip. Subpart O - Machinery and Machine Guarding. Visors or other accessory equipment shall not be included as a part of the guard when measuring the guard opening, unless such equipment has strength equal to that of the guard. How someone is dressed loose clothing, long hair, and jewelry when working on or around conveyors can present the risk of conveyor entanglement. OSHA Catwalk Requirements: Width, Load & Handrail Standards - Lapeyre Stair Belts which of necessity must be shifted by hand and belts within seven (7) feet of the floor or working platform which are not guarded in accordance with this section shall not be fastened with metal in any case, nor with any other fastening which by construction or wear will constitute an accident hazard. All surrounding floors shall be kept in good condition and free from obstructions, grease, oil, and water. Vertical belts running over a lower pulley more than seven (7) feet above floor or platform shall be guarded at the bottom in the same manner as horizontal overhead belts, if conditions are as stated in paragraphs (e)(2)(ii) (a) and (c) of this section. (vi) Equipment shall be kept clean, particularly from accumulations of yellow lead oxide. The employer shall provide clearance between machines so that movement of one operator will not interfere with the work of another. Guards. Compliance with 1910.217(h)(7). (b) Guarding of abrasive wheel machinery -. ), (4) Cylindrical grinders. Where the drive extends over other machine or working areas, protection against falling shall be provided. Paragraph (f)(1) of this section does not apply to hand-operated gears used only to adjust machine parts and which do not continue to move after hand power is removed.
Clothes Donation Bins Livermore,
Articles O
osha conveyor safety 1910